Set Up The Hardware; Connect The Power Supply - Hewlett Packard Scanjet Enterprise 9000 Guide De Démarrage Rapide

1. Decide what software to install.
• If you will be using the scanner with document-management and scanning
software that you already own, you only need to install the HP Scanjet Drivers
and Tools.
• If you do not already have document-management and scanning software, you
can use the software that is shipped with the scanner. Read the onscreen
descriptions of the software during the installation to decide what software to
install. (The software and the number of CDs that are shipped with the scanner
might vary by country/region.)
2. Insert the HP Scanning Software CD into the computer CD drive. Wait for the
installation dialog box to appear.
3. Click Install Software, and then follow the instructions on the screen.

Set up the hardware

Complete the following tasks in order to set up the scanner hardware and prepare it for
use.

Connect the power supply

The green LED on the power supply case is on when the power supply is functioning
correctly.
1. Connect the power supply to the power supply cable, and then plug the power supply
cable into a power outlet or a surge protector.
2. Check that the green LED on the power supply case is on.
• If the green LED is not on, ensure that power is available to the power outlet or
surge protector that the power supply cable is plugged into.
• If power is available to the power outlet or surge protector but the green LED is
still not on, the power supply might be defective. Contact HP Support for
assistance.
Set up the hardware 3