Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Slide the custom panels into the trims on the refrigerator door
and freezer drawer, making sure that the backer panel fits into
the hinge side trims.
4. Reinstall the handle-side and top trims.
5. Remove the protective skin from the screw covers. Snap the
screw covers into the handle trim section.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up; then pull straight out. Place the top grille
panel-side down on a soft working surface.
B
A. Top grille
B. Cabinet side trim
A. Panels
A
B
3. Remove one end cap by loosening the nuts and sliding the
end cap off.
4. Slide the panel into the top grille channel and reattach the
end cap.
A
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
NOTE: Custom or full-overlay door panels must be installed
before leveling.
1. Open the door and place the level on top of the refrigerator
frame as shown. Check to see whether the refrigerator is level
from left to right.
2. Use the leveling bolts to adjust the leveling legs until the
refrigerator is level from left to right.
A
B
A. Bottom rail
C. End cap
B. Nuts
D. Top rail
A. Panel
B
A
A. Top grille
B. Cabinet side trim
Level Refrigerator
A
B
A. Level to check left to right leveling
B. Level to check front to back leveling
A. Rear leveling bolt
B. Front leveling bolt
B
A
B
21
Publicité
Table des Matières
