How To Create An Admin Pin After A Brute Force Attack Or Reset; Setting The Unattended Auto-Lock Clock - iStorage diskashur2 Manuel D'utilisation

Masquer les pouces Voir aussi pour diskashur2:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

17. How to Create an Admin PIN after a Brute Force attack or Reset

It will be necessary after a Brute Force attack or when the diskAshur
can be used. If the drive has been brute forced or reset, the drive will be in a standby state (solid
Admin PIN proceed with the following steps.
PIN requirements:
Must be between 7-15 digits in length
Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
Note: The SHIFT key can be used for additional combinations. SHIFT + 1 is a separate value than just 1.
To create a PIN using additional combinations, press and hold down the SHIFT button whilst entering
your 7-15 digit PIN. e.g. SHIFT + 26756498.
1. In Standby state, press and hold down
"Shift (
) + 1" buttons
2. Enter NEW Admin PIN and press "UNLOCK" button
3. Re-enter the NEW Admin PIN and press "UNLOCK"
button

18. Setting the Unattended Auto-Lock Clock

To protect against unauthorised access if the drive is unlocked and unattended, the diskAshur
automatically lock after a pre-set amount of time. In its default state, the diskAshur
off. The Unattended Auto Lock can be set to activate between 5 - 99 minutes.
To set the Unattended Auto Lock, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin
Mode (solid
BLUE
LED) proceed with the following steps.
1. In Admin mode, press and hold down
"UNLOCK + 5" buttons
2. Enter the amount of time that you would like to set the Auto-Lock timeout feature for, the minimum time that can be set is
5 minutes and the maximum being 99 minutes (5-99 minutes). For example enter:
05 for 5 minutes
20 for 20 minutes
99 for 99 minutes
3. Press the "SHIFT" (
#14
) button
has been reset to create an Admin PIN before the drive
2
Solid
and solid
Blinking
switch to a single
back to blinking
Blinking
change to
seconds and then to a solid
ing the Admin PIN was successfully configured.
Solid
and
BLUE
Blinking
a solid
solid
out is successfully configured
www.istorage-uk.com
RED
LED). to create an
RED
LED will change to blinking
BLUE
LEDs
GREEN
and solid
BLUE
GREEN
LED blink and then
GREEN
and solid
GREEN
LED and solid
BLUE
BLUE
LED rapidly blinking for a few
BLUE
can be set to
2
Unattended Auto Lock feature is turned
2
BLUE
LED will change to blinking
LEDs
GREEN
and
BLUE
LEDs will change to
GREEN
for a second and then finally to a
BLUE
LED indicating the Auto-Lock time
GREEN
LEDs will
BLUE
LEDs
LED
LED indicat-
GREEN

Publicité

Table des Matières
loading

Table des Matières