Set Read-Only In Admin Mode; Enable Read/Write In Admin Mode; How To Create A Self-Destruct Pin - iStorage diskashur2 Manuel D'utilisation

12. Set Read-Only in Admin Mode

Important: If data has just been copied to the diskAshur
first by clicking 'Safely Remove Hardware/Eject' the diskAshur
reconnecting and setting the diskAshur
When Admin writes content to the diskAshur
mode. To set the diskAshur
Admin Mode (solid BLUE
1. In Admin mode, press and hold down "7 + 6"
buttons. (7=Read + 6=Only)
2. Release 7+6 buttons and press "UNLOCK"

13. Enable Read/Write in Admin Mode

To set the diskAshur to Read/Write, first enter the "Admin Mode" as described in section 5. Once the drive is in
2
Admin Mode (solid BLUE
1. In Admin mode, press and hold down "7 + 9"
buttons. (7=Read + 9=Write)
2. Release 7+9 buttons and press "UNLOCK"

14. How to create a Self-Destruct PIN

The self-destruct feature allows you to set a PIN which can be used to perform a crypto-erase on the entire drive.
When used, the self-destruct PIN will delete ALL data, Admin/User PINs and then unlock the drive. Activating this
feature will cause the Self-Destruct PIN to become the new User PIN and the diskAshur
and formatted before any new data can be added to the drive.
To set the Self-Destruct PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down
"UNLOCK + 6" buttons
2. Create a 7-15 digit Self-Destruct PIN and press the
"UNLOCK" button
3. Re-enter the PIN and press the "UNLOCK" button
#12
2
and restricts access to read-only, the User cannot change this setting in User
2
to Read-Only, first enter the "Admin Mode" as described in section 5. Once the drive is in
2
LED) proceed with the following steps.
LED) proceed with the following steps.
, make sure to properly disconnect the drive
2
from the Operating System before
2
as 'Read-Only/Write-Protect'.
Solid
and BLUE
GREEN
GREEN
indicating the drive is configured as Read-Only
Solid
and BLUE
GREEN
GREEN
indicating the drive is configured as Read/Write
Solid
and solid
Blinking
switch to a single
back to blinking
GREEN
seconds and then changes to a solid
to indicate the Self-Destruct PIN has been
successfully configured
www.istorage-uk.com
BLUE LED will change to blinking
LEDs
and BLUE LEDs will change to a solid
LED and then to a solid BLUE
BLUE LED will change to blinking
LEDs
and BLUE LEDs change to a solid
LED then to a solid BLUE
will need to be partitioned
2
BLUE LED will change to blinking
BLUE LEDs
GREEN and solid BLUE
GREEN LED blink and then
GREEN and solid
LED will rapidly blink for several
GREEN
LED
GREEN
LED
GREEN
LEDs will
BLUE LEDs
BLUE LED