PCE 35.1110 Mode D'emploi page 17

TFA_No. 35.1110_Anleit_D_GB_F
CRYSTAL CUBE – Wireless weather station
• In areas where no DCF 77 time reception is possible you can
deactivate the DCF time reception (position OFF). The clock
will then work as a normal quartz clock (default: ON).
• If the DCF reception is on, the manually set time will be over-
written by the DCF time when the signal is received successfully.
7.2 Display of clock, calendar and alarm time
• Each press on the B 1 will change the display between:
→ Clock with hour, minutes and seconds
→ Clock with hour, minutes and day of week
→ Date with day, month and year
→ Alarm time 1
→ Alarm time 2
7.3 Alarm clock function
• Press button B 1 in clock mode three times until the alarm
time 1 appears on the display.
• The alarm symbol 1 is flashing.
• Press and hold the button B 1 for 2 seconds to enter the
alarm time setting.
• The hour digits are flashing.
• Press ▲ or ▼ button to adjust hours.
• Confirm with button B 1.
• The minute digits are flashing.
• Set minutes in the same way.
• Confirm with button B 1.
• The alarm is activated.
• Press ▼ button in the alarm mode to deactivate (the alarm
symbol disappears) or activate the alarm.
• Press the button B 1 again.
32
09.05.2011 9:04 Uhr Seite 17
CRYSTAL CUBE – Wireless weather station
• The alarm symbol for the second alarm time is flashing.
• Set the second alarm time in the same way.
• After 10 seconds, the display automatically reverts to the
clock mode.
• During the alarm signal will sound the corresponding alarm
symbol is flashing.
• Press any button to stop the alarm.
• You can activate the snooze function by pressing the top of
the instrument.
• Once the snooze function is activated the alarm sound will be
interrupted for 5 minutes.
7.4 Indication indoor temperature
• Press the button B 2 to select temperature display in °C (Cel-
sius) or °F (Fahrenheit) as the temperature unit.
• With the button B 6 you can obtain the indoor temperature
and the outdoor temperature (channel 1-3).
• You can also choose an alternating channel display. Press the
button B 6 again after the last channel (1 until 3) and the
circle symbol for alternating channel appears on the display.
All outdoor transmitters and the indoor temperature will
appear alternating for 6 seconds.
• Press the button again to stop the automatically alternating
channel display.
7.5 Maximum/Minimum function
• Press the button B 5 to obtain the maximum day values
"MAX" for the temperature selected with button B 6. Press
the button B 6 again you can obtain the minimum day values
"MIN".
33