Washer Maintenance - Maytag BRAVOS XL MVWB950YW Guide D'utilisation

9.
Select cycle options
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as Clean Boost. These may be turned off,
if desired.
NOTE: Not all options are available with all cycles.
10.
Press START/PAUSE to begin
wash cycle
Press the START/PAUSE button to start the wash cycle. When
the cycle has finished, the end of cycle signal will sound (if set).
Promptly remove garments when cycle is done to avoid odor,
reduce wrinkling, and rusting of metal hooks, zippers, and snaps.
If lid is left open for more than 10 minutes the water will
pump out.
12

WASHER MAINTENANCE

WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of
replacement on the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See
the "Installation Instructions" for more information.
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this
recommended cleaning procedure after every 30 washes:
1. Make sure the washer is empty.
2. Using recommended AFFRESH
add one tablet to washer drum.
OR
If using liquid chlorine bleach, add 3/4 cup (180 mL) to
liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN
WASHER with AFFRESH
recommended amount of bleach to avoid damaging
product over time.
3. Close washer lid.
4. Press POWER/CANCEL.
5. Select CLEAN WASHER with AFFRESH
6. Press START/PAUSE. Water will pour into washer
for a moment and pause, lid will lock, then cycle
will continue.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted, press START/PAUSE twice and run
a RINSE/DRAIN & SPIN cycle to ensure cleaner or bleach
have been rinsed from washer.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose surface cleaner, if needed.
IMPORTANT: To avoid damaging the washer's finish,
do not use abrasive products.
washer cleaner,
®
cycle. Do not use more than
™
cycle.
™