The 'Fuel' Indicator Light - Zibro SRE 159 E Manuel D'utilisation

temp.
clock
J: When the SAVE light
lights up, the heater will
automatically switch on
or off in order to remain
within a specified
temperature range.
room
K: When the FUEL
indicator light is lit, the
information display will
show the number of
minutes of fuel left in
the tank.
L: A blinking VENT
indicator light is a sign
that you need extra
ventilation.
M
Fuel filter
N
light will light up (Fig. J). Switch off the function by pressing the SAVE key once
again.
Without the 'SAVE' setting your heater will maintain the set temperature by
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
K

THE 'FUEL' INDICATOR LIGHT

When the FUEL indicator light lights up, there is enough fuel left for another 10
minutes of heater use. The count-down of the remaining heating time can be seen
in the information display ¹ (Fig. K). Every two minutes an alarm signal is
sounded, warning you to refill the removable tank. If you do not react, the heater
will extinguish by itself. The heater will also sound a warning signal, when it
switches off. The FUEL indicator light will blink, while four lines are blinking in the
information display. You can stop this by pressing the
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
L
THE 'VENT' INDICATOR LIGHT
When there is insufficient ventilation in the room, an intermittent buzzer will be
heard (approximately once each ten minutes) and the VENT indicator will be lit.
When this signal is given, ensure that the ventilation of the room is improved (e.g.
by opening a door or window a little more), to avoid that the heater shuts off.
When the ventilation of the room is improved, the VENT indicator and buzzer will
be deactivated. When there is still insufficient ventilation, the heater shuts off
automatically. When this occurs, e -1 1 is displayed and the VENT indicator is blinking.
After improving the ventilation of the room (e.g. by opening a door or window a
little more), the heater can be ignited by pushing the
M
MAINTENANCE
Switch off the heater and let it cool down, before you start any maintenance
work. Also disconnect the plug from the mains.
Your Zibro needs hardly any maintenance. It is, however, important that you clean
the air filter cap
with a damp cloth, both on a weekly basis. Remove the air filter cap occasionally
(Fig. M) and clean it with soapy water. Prior to reinstallation, make sure that the
air filter cap has fully dried.
Regularly inspect the fuel filter as well:
1 Remove the removable tank
(Fig. N). Some drops may leak from the filter; keep a cloth at hand.
2 Remove the dirt by tapping the fuel filter upside-down against a hard surface.
(Never clean it with water!)
3
Reinstall the fuel filter into the heater.
and the vent filter with a vacuum cleaner and the grid
from the heater and remove the fuel filter
button once.
button again.
4
49