Specifications - Matco Tools MC1300 Manuel D'utilisation

Troubleshooting
PROBLEM
Charger will
not turn on
when properly
connected.
Engine start does
not work.

14. SPECIFICATIONS

Input .................................................. 120V AC @ 60Hz, 10A continuous, 65A intermittent
Output .......................................................................................6/12V DC, 15A intermittent
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical connection.
Battery is defective.
Drawing more than the Engine Start
rate.
Failure to wait 3 minutes
(180 seconds) between cranks.
The charger may be overheated.
Battery may be severely discharged.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for loose fitting plug.
Have the battery checked.
Crank time varies with the amount
of current drawn. If cranking draws
more than the Engine Start rate,
crank time may be less than 5
seconds.
When the Engine Start
blinks, wait 3 minutes of rest time
before the next crank.
The thermal protector may have
tripped and needs a little longer to
reset. Make sure the charger vents
are not blocked. Wait and try again.
On a severely discharged battery, use
the 50A Boost
minutes, to help assist in cranking.
6/12V DC, 50A int., 60 sec. on, 120 sec. off
6/12V DC, 250A int., 5 sec. on, 180 sec. off
• 11 •
SOLUTION
LED
rate for 10 to 15