Controlling Your Marmitek X-10 Modules - Marmitek IR455 B&O to X-10 converter Mode D'emploi

4. CONTROLLING YOUR MARMITEK X-10 MODULES

The IR455 uses the following buttons on your B&O remote control.
LIGHT:
0 t/m 9:
GREEN, YELLOW, RED, BLUE: Choose the desired setting.
GO:
STOP:
Marmitek X-10 modules are all set to an address, consisting of a
letter (HouseCode) and a number (UnitCode). The IR455 is
configured to control Marmitek X-10 modules set to the addresses
A1-A16.
Settings (standard):
LIGHT - 1 - GO:
LIGHT - 1 - STOP: Module A1 OFF
L:
LIGHT - 1 -
LIGHT - 1 - M:
LIGHT - 2 - ...:
till
LIGHT -16 - ...:
The Marmitek X-10 system contains a function with which you can
turn all lights (on one HouseCode) on or off at the same time. To
activate this function, use the green button.
All lights on HouseCode A ON:
All modules on HouseCode A OFF:
NB 1: You can select the UnitCodes 10-16 by pressing both
numbers consecutively. E.g. to select the module on
Press LIGHT to make sure the remote
control will work with the IR455.
Choose the lamp, device or setting
you wish to control (1-16).
ON/activate the setting
OFF
Module A1 ON
Module A1 BRIGHTER
Module A1 DIM
same for module A2
same for module A16
LIGHT - GREEN - GO
LIGHT - GREEN - STOP