How Does It Work; Installation Of The Ir455 - Marmitek IR455 B&O to X-10 converter Mode D'emploi

2. HOW DOES IT WORK?

Aim the BEO4 infrared remote control at the 'B&O to X-10 converter'. The XM10 power line
modem (available separately) transmits the command to your lights and equipment via the
mains. No extra wiring necessary.
XM10
Equip all lamps and appliances which you wish to control remotely with a Marmitek X-10
module. This module makes sure the device or light can be dimmed or switched on and off.
Marmitek X-10 modules are available in several versions. A short description of the available
X-10 modules can be found in chapter 6.

3. INSTALLATION OF THE IR455

1. Connection for the cable to the XM10
power line modem
2. Connection for the power adapter
3. Connection for the cable to the PC
(see chapter 5.1)
4. Position for inserting the table stand
• Plug the XM10 connection cable into the
X-10 port (1) of the IR455. Plug the other
end of this cable into your XM10 power line
modem. Make sure you hear a clear audible
'click' when you connect the cable.
• Connect the power adapter to connection (2).
• Plug the power adapter and the XM10 power line modem into a wall socket.
• The IR455 is now ready for use.
NB: Do not place the IR455 close to a plasma screen. The radiation of the screen can disrupt
the infrared signal to the IR455.
IR455
MARMITEK X-10 modules
3
1
2
4
5