Bosch HES7282U Mode D'emploi Et D'entretien page 21

Delaying the Start of a Timed Mode
To Check the Cooking Time and
Stop Time After a Delay Has Been
Set
Setting the Sabbath Feature
Using the Probe (some
models)
Setting the Probe
1. Follow steps 1 through 5 above.
2. Turn knob until DELAYED BAKE appears.
3. Press Time. SET BAKE TIME appears in dis-
play and minutes flash.
4. Set minutes and then press TIME. Hours Flash.
5. Set hours and then press TIME. SET BAKE END appears in the display.
6. Press TIME.
7. Use knob to enter the time of day the oven will stop cooking or turn off.
8. Set hours and then press TIME.
9. Set minutes and then press TIME.
Note: The clock automatically calculates time of day at which cooking mode
starts and stops. The displayed cooking time counts down by the minute.
10. At the end of the programmed cooking time, the oven will automatically turn
off. Display will show TIME COOK END and reminder beeps will sound. Press
OFF to clear.
Note: Remove food from oven immediately after cycle has finished to prevent
overcooking. Food left in the oven will cook even after the cycle is complete.
1. Press Time.
2. Turn knob to BAKE END or BAKE TIME.
3. Press Time.
See "Set the Sabbath Feature" on page 13.
This section explains how to operate the probe. See "The Probe (some models)"
on page 25 for guidelines, tips and suggestions.
The probe can be used to determine the internal doneness or the "END" tempera-
ture of many foods,especially meats and poultry.
The temperature range for the probe is 135°F to 200°F (57°C to 93°C). Oven tem-
perature can be set for 100°F up to 450°F (38°C up to 232°C).
1. Prepare meat and place in roasting pan (or on rack in roasting pan as recipe
specifies). Insert the probe into the meat. Make sure the probe is not touching
gristle, fat, bone, the roast rack or the pan. See "Inserting the Probe" on
page 25 for detailed instructions.
Note: Do not connect to probe receptacle until probe tip is properly inserted into
meat.
2. Place roasting pan with meat in cold oven on recommended oven rack. Plug
probe into the probe receptacle. The probe symbol will appear in display.
Note: The probe temperature can only be set when the probe is installed in the
oven.
3. Press COOKING MODE and select BAKE, CONVECTION BAKE or CON-
VECTION ROAST.
4. Press START. The default oven temperature will appear.
5. Turn knob to change oven temperature if necessary.
6. Touch START.
7. Turn knob to set the probe temperature (desired end temperature of the food).
8. Press START.
The chosen oven temperature is displayed in the upper right hand corner of the
display.
Operation - Oven
5: 00
400
o
PM
F
DELAYED BAKE
HR:MIN
English 19