Mounting The Converter; Mounting Instructions - Waeco PerfectCharge DC08 Notice De Montage Et D'utilisation

_DC Power Booster.book Seite 26 Mittwoch, 11. April 2007 8:31 08

Mounting the converter

No. in fig. 1,
page 3
7
8
9
6 Mounting the converter
6.1

Mounting instructions

If you wish to mount the converter in a fixed position, please observe the
following mounting instructions:
You can mount the device either horizontally or vertically.
Do not mount the device
– In wet or damp environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions
The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, closed spaces. The minimum
clearance around the device must be at least 5 cm (fig. 2, page 3).
The air intake on the underside or the air outlet on the back of the device
must remain clear.
For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the device under load can
lead to the automatic shut-down.
The installation surface must be level and sufficiently sturdy.
Caution!
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
26
Explanation
Positive cable (red) to input battery
Negative cable (black) to input battery
Connection for switching on with on-board voltage
(e.g. ignition or external switch)
PerfectCharge / PerfectPower