Additional Information - Sony TDG-BT500A Mode D'emploi

To replace the battery
If the LED indicates low battery power
(indicator blinks green (yellow when
SimulView™ mode) 3 times every
2 seconds), replace the battery. Use a
CR2025 battery only. Press the unlock
button with the tip of a pen, etc, and take
out the battery case, then replace the
battery with a new one. After that, be sure
to lock the battery case again.
Tips
If you wear glasses, remove the nose pad
ˎ
of the Active 3D Glasses by pulling it
down, then wear them over your glasses.
Notes
Power off the Active 3D Glasses, when
ˎ
re-register the glasses.
The glasses turn off if you hold the power
ˎ
button down for 2 seconds, or if no signal
from the TV is detected for more than
1 minute.
3D effect or SimulView™ effect may be less
ˎ
pronounced if ambient temperature is
low.

Additional Information

Troubleshooting
In the event of a problem, refer to i-Manual on your TV.
Refer to Sony website for the latest information.
For Asia
For Taiwan
For Latin America
For Brazil
http://www.sony-asia.com/support
http://www.sony.com.tw/service
http://esupport.sony.com/LA/
http://esupport.sony.com/BR/
Unlock button
CR2025
(-) side
GB
GB
7