Sony TDG-BT500A Mode D'emploi page 6

Steps
1
Remove the battery's insulating
sheet before using the product
for the first time.
2
When using Active 3D Glasses for
the first time, hold the glasses
within a 50 cm range of the TV
and turn on the TV and hold the
1 (Power) button/indicator for
2 seconds. The Active 3D Glasses
turn on and registration starts
(The 1 (Power) button/indicator
blinks green and yellow). When
registration is finished, a message
appears in the bottom right of
the screen for 5 seconds, and the
indicator will light up green for
3 seconds. This process is only
required one time.
If registration fails, the Active 3D
Glasses will turn off automatically.
In this case, repeat the above.
To turn on and off
To turn on : Press once the power button.
To turn off : Hold the power button down for 2 seconds.
To use the SimulView™ mode
SimulView™ allows two players to view independent screen images in full screen
while playing the same game on a shared screen. The image is displayed in 2D. To
use this feature, the game software and the TV must support SimulView™.
When using this mode, the Active 3D Glasses automatically change to SimulView™
mode. Every press the button of the Active 3D Glasses can switch between the
players as follows.
Mode: SimulView™ mode (Player 1) y SimulView™ mode (Player 2)
ˎ
Indicator: Green LED blinks every 2 seconds with SimulView™ mode (Player 1) y
ˎ
Yellow LED blinks 2 times every 2 seconds with SimulView™ mode (Player 2)
GB
6
1 (Power)
button / indicator
Insulating
sheet