Metabo HPT RP 3608DA Mode D'emploi page 16

English
Handle
Filter
Tank
(2) Insert the cloth fi lter so that the seam is on the
other side of the hose inlet. (Fig. 14)
Filter seam
(3) Check that the fi lter packing is put on the mouth
of the tank. (Fig. 15)
Filter packing
Mouth of the tank
Filter
(4) Check that the fi lter cage is on the bottom of the
fi lter. (Fig. 15)
3. Attach the zoom pipe, master nozzles, etc.
When it is used as a cleaner (Fig. 16)
(1) Connect in order of Hose id 1-1/2" × 4.9 ft (id
38 mm × 1.5 m long), zoom pipe and Master
nozzle. Connection is done by pressing in the
direction of the arrow. The suction mouth for
crevices can also be attached depending on
the application.
16
Head
Filter cage
Clamp
Fig. 13
Filter
Suction opening
(Inside of the tank)
Fig. 14
Filter cage
Fig. 15
Zoom pipe
Master nozzle
(2) Next, loosen the screw ring on the zoom pipe
and adjust to the length appropriate to the task.
After the adjustment, make sure the screw ring
is secure by securely tightening it. (Fig. 17)
Screw ring
Zoom pipe
4. Connect power tools (Fig. 18)
Connect in order of Hose
38 mm × 1.5 m long) and Adapter or Joint (D)
(Optional Accessory). Connection is done by
pressing in the direction of the arrow.
NOTE
Depending on the operating environment, the
main unit's temperature protective function
may activate and switch off the unit.
Should the unit switch off , refer to
TROUBLESHOOTING GUIDE (Page 23).
Hose id 1-1/2" ×
4.9 ft (id 38 mm ×
1.5 m long)
Fig. 16
Release
Fix
Fig. 17
id 1-1/2" × 4.9 ft
(id