Hitachi 50HAK6152 Manuel D'utilisation page 2

1
Insert the batter es nto the Remote Control
Remove the screw that secure the battery compartment cover on the back side of the remote
control first. Lift the cover gently. Insert two 1.5V - size AAA batteries. Make sure the (+) and (-)
signs match (observe correct polarity). Do not mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on. Then screw the cover back on again.
2
Connect the antenna to your TV
3
Connect the TV to the ma ns socket
4
Sw tch the TV on
After plugg ng the power cable to the ma ns socket outlet the
TV w ll sw tch on automat cally. If the TV is in standby mode
the standby LED lights up.
To sw tch on the TV from standby mode e ther;
1. Press the Standby button on the remote control.
2. Press the centre of the control sw tch on the TV n.
Qu ck Start Gu de
Engl sh
REAR SIDE OF THE TV
CABLE
SATELLITE
AERIAL
or