Pairing The Wireless Flush-Mount Actuator With Switch Wiring With The Brematicpro Wireless Remote Control; Unpair; Pairing The Wireless Flush-Mount Actuator With Switch Wiring With The Brematicpro Gateway - brennenstuhl BREMATIC PRO SmartHome Mode D'emploi

Pairing the wireless flush-mount actuator
with switch wiring with the BrematicPRO
Wireless Remote Control
The wireless flush-mount actuator with switch wiring can be paired
directly with the BrematicPRO wireless remote control. For further
options, see the compatibility list at: www.brematic.com/en/service.
Press and hold the pair button for 3 seconds.
The LED will flash red.

Unpair

Wireless flush-mount actuator with switch wiring 868.3 MHz
Whilst the LED is flashing,
press a button on the left
of the BrematicPRO
wireless remote control
you wish to program for
the device.
Once the devices have
been paired the LED of
the actuator will light up
green. The pairing process
is now completed and the
actuator is switched on.
Press and hold the pair
button for 3 seconds.
The LED will flash red.
Pairing the wireless flush-mount actuator
with switch wiring with the BrematicPRO
Gateway
When linked with the Home Automation Systems BrematicPRO via
the BrematicPRO Gateway, you can use the app / BrematicPRO PC
software to use additional functions, e.g. timer control, theme control,
astro function (dawn / dusk control).
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the Gateway.
Open the "Settings" menu.
Select the room where you wish to use the device.
Select the frequency "868 MHz".
Select "Add Device".
Under "New Device", select "Switch / Socket" and click "Continue"
to confirm your selection.
Follow the on-screen instructions.
Press and hold the pair button on the device for 3 seconds.
Enter a device name, e.g. "Living Room Lamp".
Select "Add" to assign the device to the room.
First tap "Back" to leave the room, then "Done" to complete the
pairing process.
The wireless flush-mount actuator with switch wiring is now
connected to the Home Automation Systems BrematicPRO.
Use "Test Device" to switch the consumer on and off to ensure the
wireless flush-mount actuator with switch wiring is working
properly.
In this submenu you can also add the device to your favourites.
For more information about the app and how to use it, please visit
our homepage at: www.brematic.com/en/service.
Whilst the LED is flashing,
press the respective
button on the right of the
BrematicPRO wireless
remote control you wish
to unpair. This completes
the unpairing process.
EN 13