Installing The Range Hood - Vissani U5H300A15 Manuel De L'utilisateur

Installation (continued)

INSTALLING THE RANGE HOOD

DANGER:
Turn off the power circuit breaker or the
power switch on the junction box before installing this
unit . Touching circuitry inside the range hood while it is
energized will result in death or serious injury .
DANGER:
If installing this unit over a gas range, turn off
the gas at the source before installing or servicing this unit .
- Lift the range hood (A) up under the cabinet to determine its
final position. Mark the location of the four keyhole mounting
slots (1) on the underside of the cabinet .
- Set the range hood (A) aside on a protective surface .
- Drill four pilot holes in the locations that you marked .
- Screw the four long tapping screws (AA) into the pilot holes .
Do not tighten the screws all the way – leave the screw heads
about 7 mm (0.28 in) from the cabinet surface.
- Lift the range hood (A) into position, feeding the power cable
and the electrical wires through the power access opening .
Allow some slack in the cable and wires so that the appliance
can be moved if servicing is ever necessary .
- Position the range hood (A) so the large end (2) of the keyhole
mounting slots (1) are over the screws (AA) . Then push the
range hood (A) toward the wall so the screws (AA) are in the
neck (3) of the keyhole slots . Tighten the screws (AA) . Ensure
that the range hood (A) is securely fastened to the cabinet
before releasing it .
- If applicable, connect the duct work to the range hood (A) .
Seal the joints with duct tape to ensure an airtight fit.
FINAL STEP
- Reconnect the power supply cable and wires to the electrical
supply .
- Re-install the bottom panel and the filters. Ensure that the
holes beside the fan guard align with the holes on the bottom
panel before inserting the screws .
- Turn the power on and ensure that the lights and fan are
operating correctly .
AA
1
A
12
AA
1
AA
2
1
3