Profile 545144210 Mode D'emploi page 71

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

545144210
TROUBLESHOOTING
This unit should only be repaired or disassembled by a qualified person. If problems persist, contact
the manufacturer. Improper repair will void the warranty and may cause the device to malfunction,
resulting in injury and property damage. Only use the unit in accordance with the instructions in this
operating manual and only carry out the actions recommended here.
PROBLEM
The air conditioner
does not work.
The
cooling
or
heating effect is poor
The air conditioner is
leaking
Compressor does not
work.
The remote control
does not work.
MONOBLOCK AIR CONDITIONER
REASONS
There is no electricity.
The ambient temperature is
too low or too high
In cooling mode, the room
temperature is lower than the
desired temperature; in
heating mode, the room
temperature is higher than
the desired temperature.
In dehumidification (dry)
mode, the ambient
temperature is low.
There is direct sunlight.
Doors or windows are open;
there are a lot of people; or
in cooling mode, there
are other sources of heat (e.g.
fridges)
The filters screen is dirty.
The air inlet or outlet is
blocked.
The unit is not straight
The drain pipe is blocked
Overheat protection
operational
The distance between the
machine and the remote
control is too far.
The remote control is not
aligned with the direction
of the remote-control
receiver.
Batteries are dead.
SOLUTIONS
Check the unit is plugged in, and the
socket is working normally.
Only use to use the machine with a room
temperature between 7 and 35°C
Adjust the desired room temperaure
Ensure that the room temperature is
above 17°C for dry mode.
Use curtains to reduce heat from the sun
Close doors and windows; increase air
conditioning power
Clean or replace the filter screen.
Clear obstructions; make sure the unit is
installed as per the instructions
Use a spirit level to check the unit is
horizontal, if not remove from the wall
and straighen
Check the drain pipe to ensure it is not
blocked or constricted.
Wait for 3 minutes until the temperature
is lowered, and then restart the machine.
Let the remote control get close to the air
conditioner, and make sure that the
remote control directly faces to the
direction of the remote-control receiver.
Replace batteries.
NL
16

Publicité

Table des Matières
loading

Table des Matières