Profile 545144210 Mode D'emploi page 70

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

545144210
FAN SPEED
TIMER
UP/DOWN
SING MODE
COMPRESSOR
PROTECTION
MONOBLOCK AIR CONDITIONER
The 'heating' mode defaults to 24°C and heats the air inside
while sending cool air outside. The desired temperature can
be set with the UP/DOWN buttons between 16°C and 30°C.
The fan speed can be adjusted using the speed knob.
HEATING
Silent/sleep mode can be activated from the app or the
remote control. It will only operate in the cooling or heating
mode. The fan speed will change to low and the device will be
SILENT
quieter.
Press the FAN SPEED button to change the fan speed between
Low, Medium and High. The fan speed cannot be adjusted in
"dehumidifying" or sleep mode.
The 24-hour timer can be used to set a delayed start or a set operating
period. The timers cannot be combined. However, different operating
periods can be combined in the app.
SHUTDOWN TIMER: While the unit is ON: press the timer button; the
display shows "0" 5 times. After the 5th flashes; use the UP/DOWN
buttons to set the time period in 1-hour intervals (min. 1, max. 24 hours).
When the timer has expired, the unit will automatically turn off.
DELAYED START TIMER: While the unit is ON: press the timer button; the
display shows "0" 5 times. After the 5th flashes; use the UP/DOWN
buttons to set the time duration in 1-hour intervals (min. 1, max. 24
hours). After this interval has elapsed, the unit will automatically turn on in
the same mode it was in when it was last turned off.
Used in cooling and heating modes to set the desired room temperature.
Also used when setting the timer to adjust the duration.
While the unit is ON: press the SWING button. The blind will now swing up
and down automatically. Press the SING button again and the blind will
remain in its current position. The swing mode can only be set with the
remote control and is on by default.
There is a 3 minute delay when switching on. To protect the life of the
compressor and electronic components, wait at least 5 minutes to turn the
unit back on after turning it off.
NL
15

Publicité

Table des Matières
loading

Table des Matières