Lubrication - Swiss Made Xplorer Traduction De La Notice Originale

Abb. 13
1.5 - 2 mm
Abb. 14
► Work only with sharp clipping blades and replace dull blades and blades with mis-
sing teeth. Proper sharpening of clipping blades is only possible by an expert using
specialised equipment. When faced with the need to sharpen the blades, contact your
service centre.

7.9 Lubrication

Abb. 15
Cattle and Horse Clippers
Place the new upper blade onto the guiding tips
‹
of the swivelling lever.
Apply a few drops of oil on the polished sur-
‹
faces of the upper blade.
Install the new lower blade. Align it so that the
‹
ground surface of the lower blade protrudes ap-
prox. 1.5 - 2 mm above the point of the upper
blade.
Tighten the comb plate screws.
‹
NOTE
To achieve a well-clipped animal and to increase
the life of the device including the clipping head, it
is necessary to apply a thin coat of oil between the
upper and lower blades. All other moving parts of
the clipping head must also be lubricated.
Apply some drops of oil onto the clipping blades
‹
and into the lubrication opening.
39