Problems
Problem
The helicopter does not react
The motor does not turn
The helicopter is uncontrollable
The helicopter fails to climb
The helicopter lands too hard
The transmitter is not working
Because of its delicate construction, damages can arise if the helicopter crashes. These damages are not covered by the
warranty.
22
Possible Cause
No Power
The receiver is not receiving a signal
The batteries in the model or the trans-
mitter are empty
The motor is too hot
The connection between the model
and the motor has been broken
The motor is worn out
The transmitter antenna is not screwed
in securely or is not fully extended
The wind is too strong
The rotor blades are not spinning fast
enough
The flight battery is not fully charged
The throttle stick was pulled back too
fast
The transmitter is not switched on
The batteries are incorrectly fitted
The batteries are empty
Possible Cure
Check the connection between the
flight pack (battery) and the model
Make sure that the helicopter and the
transmitter are on the same channel
Charge the flight pack or, change the
transmitter batteries
Allow the motor to cool down
Check the cables and re-solder if ne-
cessary
Replace the motor
Screw the antenna in and fully
extend it
Do not fly in wind
Push the throttle stick further forward
Fully charge the battery
Pull the throttle stick back gently to
softly land the model
Switch the transmitter on
Fit the batteries correctly
Replace the batteries