Kobra SSD Mode D'emploi page 34

CHECKING CENTRAL ROTOR AND CUTTING BLADES
(bottom group)
You are advised to carry out periodic visual checks of the condition of the central rotor and cutting blades as
follows:
Open the front panel "A"
-
Fix holding bars "G" through their own screws as shown in picture "A"
-
Unscrew the blocking screw "B".
-
Take out the second stage mechanism "C" as shown in the diagram.
-
- Visually inspect the condition of the central rotor "D", check the cutting edge of the central
rotor for excessive wear, major signs of breakage, deep cracks, etc..
Remove the screen "E" by unscrewing the knob and lowering the screen holder.
-
Visually inspect the condition of the fixed cutting knives as shown in figure "F", then check
-
the cutting edge of the blades for excessive wear, major signs of breakage, deep cracks, etc..
When the check is finished, if the central rotor and cutting knives do not need any extraordinary
maintenance (sharpening), put them back in position as follows:
Replace the screen "E" on the screen holder and then fix it in place by tightening the knob.
-
Push the second stage in as far as it will go and fix it in place by tightening the screw "B".
-
Remove holding bars "G"
-
Replace the waste collection bin and close the front panel again.
-
33