Maintenance - Kobra SSD Mode D'emploi

MAINTENANCE

Before carrying out any maintenance or repairs on the internal parts of the machine, disconnect the
power plug from the outlet.
Cleaning:
The KOBRA model SSD is equipped with an hour meter (figure "B") which must be monitored to provide the
necessary maintenance as following:
Every 8 hours of operation:
open the top turret and remove any debris which has built up on the cutters and combs or
-
the walls of the shredding chamber.
Visually inspect the cutters for damage.
-
Open the front door and empty the collection bin.
-
- screen (figure "A"):
Unscrew the knob, lower the screen holder and extract the screen as illustrated in figure "A".
Remove any debris which may have built up on the screen and visually inspect that the
screen for damage.
Replace the screen on its holder and secure with locking knob screw.
-
Clean off excess debris inside the collection bin area.
-
Clean all surfaces inside the collection bin area and outside the machine with a damp cloth.
-
Lubrication: Daily lubrication of the first stage mechanism with KOBRA oil is recommended for optimum
performance and to prolong the life of the cutting mechanism. Lubrication must be done manually, applying
KOBRA oil to the inside of the shredding chamber of the top cutting mechanism as illustrated in figure "A".
WARNING! Wear gloves and safety glasses!
WARNING! Never use synthetic oil, benzene-based products or any type of aerosol products for cleaning
the inside of the machine or cleaning in the vicinity of the machine.
FIGURE "B" FIGURE "A"
30