Cleaning The Filters - Verso M410 Mode D'emploi

5 After use

5.3 Cleaning the filters

ATTENTION:
The filters are washable, but not suitable for
cleaning in washing machines or dishwash-
ers. Also, do not use detergents or brushes
with hard bristles to clean the filters. Let the
filters dry for approx. 24 hours at room tem-
perature after cleaning. Only put them back
into the appliance when they are completely
dry.
12
13
22
The filters can get dirty after a time. There-

fore, it is important to check the filters regular-
ly and clean them if necessary.
Make sure you always clean the filters be-

fore and after wet vacuuming.
If you see that one of the filters is dam-

aged, replace it immediately (Chapter 6.2,
"Accessories and spare Parts").
To check and clean the filter elements,
proceed as follows:
1. Switch off the appliance.
2. Empty the dust container, Chapter 5.1,
"Emptying the dust container".
3. Remove the permanent filter with its in-
serted foam plastic motor protection filter.
4. Hold the permanent filter together with its
foam plastic motor protection filter low
over a dustbin.
5. Pull the foam plastic motor protection filter
out the permanent filter (Fig. 12).
6. Tap the dust out of the filters and remove
coarse dirt by hand.
7. If this is insufficient, use a soft brush to re-
move residual dirt.
8. If this is still insufficient, rinse the two fil-
ters elements under cold or hand-warm
running water (Fig. 13).
9. Let the filters dry for approx. 24 hours at
room temperature after wet cleaning. Only
put them back
(Chapter 5.4, "Fitting the filters") when
they are completely dry.
into the appliance