Foreword; Set-Up; Placement; Electrical Connection - Enraf Nonius Crosswalker Mode D'emploi

1 Foreword

Thank you for purchasing the Crosswalker. This ergometer will bring great flexibility to your
cardiovascular training routines.
The packaging contains 1) the Crosswalker, 2) these Operating Instructions.
In general, six of our products can be used for cardiovascular training. In addition to the Crosswalker (fig.
1, page 29), these include the Step, the Stair, the Bike Reha, the Cruiser and the EN-Mill treadmill.
When designing this ergometer a great deal of work went into ensuring that it was reliable, safe, user-
friendly and durable. To ensure that you use your Crosswalker properly and safely it is important that you
read through the following instructions before you start using it.

2 Set-up

2.1

Placement

If the floor is uneven then the height of the two rubber feet on the crossbars can be adjusted to
compensate. These feet can easily be rotated and fixed into position using suitable tools.
2.2

Electrical connection

To supply power to the electronics a protective earthing 230V socket is required.
2.3

Initial use

After placing the Crosswalker in position you must wait for several hours before you can use it for the first
time! This is necessary because of possible condensation caused by large differences between internal
and external temperatures.
2.4

Environmental information

During the use of the Crosswalker no emissions appear that are outside the permissable range and that
will cause any environmental burden.
Your Crosswalker contains no materials which are noxious for the environment. As thus, at the end of the
duration of life, no special concern is needed. However, specialised companies can take apart the
Crosswalker and sort out the materials for recycling. By doing so you contribute to a better environment.
Please ensure that you are well informed of the local rules and regulations regarding to the
removal of equipment and accessories.
27