Magnat XTC 300 Mode D'emploi page 11

THE FOLLOWING POINTS SHOULD BE HEEDED WHEN CHOOSING
COMPONENTS:
• Although core coils offer a good price-performance ratio, they also penetrate the
saturation region, which results in acoustic distortions. The coils should therefore have
as little ferrite / iron content as possible.
• Be sure to adhere to the recommended minimum cable diameter.
• With regard to condensers, electrolyte condensers with the highest possible electric
strength should be used.
• The components should not be mounted directly on the speaker. Secure the parts
with screws, cable ties and hot-setting glue. Keep the cable runs as short as possible.
• The components are available from specialist electronic equipment dealers.
CABLES TO BE USED
To transport the output from the amplifier to the subwoofer efficiently and reliably, you
should bear in mind when selecting the speaker cable that 2 x 4 mm
required for cable lengths in excess of 3 meters. 2 x 2.5 mm
shorter runs. Lay the cable in such a way that short-circuiting cannot occur, i.e. the cable
may at no time be jammed between metal parts. Make sure that terminals on the
speaker are screwed tight and check their contact at regular intervals.
SUBWOOFER POLARITY
Because of the different spatial conditions prevailing in different vehicles, subwoofer
polarity can best be determined by trial and error. To do this, choose some music
material you know very well and select the setting you like most. Some radios / control
units also offer the possibility of setting the polarity on the appliance itself (phase). One
change in polarity corresponds to a phase shift of 180 degrees.
GB
11
2 gauge wiring is
2 cable is sufficient for