Section 4: Installation - Blendtec DESIGNER Série Guide Du Propriétaire Et De L'utilisateur

3.2 BLENDER JAR ASSEMBLY
The blender jar assembly consists of the blender jar, blade assembly and lid�
• Jar: Durable, BPA-free jar; easy to clean�
• Blade Assembly: Uniquely designed stainless steel blade provides fast,
consistent blending�
• Lid: Vented gripper lid seals liquids within the jar during blending�
NOTE: Filling the blender jar beyond the marked capacity is not recommended.

SECTION 4: INSTALLATION

1� Place the blender on a flat, clean and dry surface� Blender vents should be
unobstructed to allow proper cooling during use�
2� Make sure an outlet is available within 61 cm (two feet) of the blender motor�
3� Place appropriately filled blender jar, with the lid in place, onto the blender base�
4
FIGURE 1: BLENDER JAR ASSEMBLY
Lid
Plunger-Free
Easy-Clean Jar
Blade Assembly
The jar shown above is the Wildside+ Jar
™
FIGURE 2: MOTOR BASE
Hardened Metal
Drive Socket
LED Information Centre
Smart Touch
Interface
Power Unit
Clear Vented
Cap Insert
Motor Base Cover
Power Cord
located in back
5