Inspection Schedule - REMA CSV Série Mode D'emploi

11a CONDITIONS
This warranty only covers failures in the lifting tools which is the consequence of production
errors which occur during normal use. The warranty covers no wear to components such as
pivots, cam assemblies, lock springs etc. Should there be any kind of failure within this guarantee
period, the lifting tool will be replaced or repaired to insight of the producer No warranty is given to clamps
due to the following failures:
- Regular wear
- Overload.
- Wrong and/or carelessly use
- Damages
- Not following procedures and measures
- Hoisting differing material other then indicated on clamp or stated in the user-manual
- Adapting and/or modifying of the REMA clamp.
- The injudicious use of the clamp, and not succeeding all indications which are stated in the users manual.
- When maintenance and/or revision has not been carried out by an authorised REMA distributor.
The producer is not responsible for incidental damage or damage due to use of the lifting tools as well as
from violation of this manual.
11b PROCEDURE SAFETY INSPECTION
All inspections and repairings must be written down in the maintenance diagram.
This counts not only for your own inspections but also for inspections which are carried out
by your authorised REMA distributor. When the clamp is handed in for maintenance and inspection
you always must provide the maintenance diagram.
Defective Lifting Clamps
When a form of wear or damage is indicated, you must take the following measures.
1 Take the lifting clamp out of use. (Note the date of failure of the lifting clamp)
2 Try to recover the cause of the failure, for example (complete list is available in chapter 1):
- Overload
- Wrong and/or carelessly use
- etc
These claims stated in no.2 do not fall under the guarantee! To guarantee the security of
you and your colleagues you are obliged to follow up this procedure.
3 Return your lifting clamp (with the maintenance history) to your authorised REMA distributor.
4 If the lifting clamp has been revised / repaired by your distributor, you can safely use your
clamp again. Please note this date in your maintenance chart (see page 35).
11c INSPECTION SCHEDULE
Months
Years
Safety inspections
by your own
inspector
Maintenance by an
official REMA
distributor
Revision by a official
REMA distributor
4 8 12 16 20 24 28 32 36 40 44 48 52 56 60
1 2 3
14
4 5