Overhauling; Disposal; Troubleshooter's Checklist; Warranty - REMA CSV Série Mode D'emploi

CBS
Important! Before starting disassembling the clamp, mark each part in such a way that they
are easily reassembled in the original position.
Disassembling the CBS
- Remove the retaining pin (5), with which the lifting shackle spindle (3) is secured, from
the frame (1).
- Remove the lifting shackle spindle (3) and the lifting shackle (4).
- Unscrew the screw spindle (2) from the frame (1) and remove it.
Assembling the CBS
When reassembling the clamps, assemble all parts in reverse order. To ensure the safety of
the clamp, only use the original REMA replacement parts when repairing the clamp. Make
sure they are marked to allow proper identification. If you carry out any inspections, repairs or
modifications yourself, you will nullify all forms of guarantee and product liability.
After inspection, repair and/or reassembly, the clamps should be tested using a certified testing
bench.

8 OVERHAULING

At least once a year or in case of any damage to the clamp, the clamp should be inspected,
tested and if necessary overhauled by REMA Holland B.V. or by a recognised mechanical
repair centre. If in doubt consult your supplier.

9 DISPOSAL

Once it the clamp has reached its life cycle end, the clamp can be treated as scrap iron, provided
that the clamp is rendered unfit for further use.

10 TROUBLESHOOTER'S CHECKLIST

Failure/malfunction
Clamp is shifting
Lifting shackle pivoting badly
Body bent
Lifting shackle oval
Shackle pins bent
Retaining pins missing
Clamp difficult to open/close

11 WARRANTY

REMA Holland Clamps provides a 5 year warranty on its lifting clamps. This warranty is applicable
to the original end user of the lifting clamps. Only if the clamp has been inspected,
checked and maintained by this instructions and by an official dealer. This warranty period
of 5 years is valid from the day of purchase, and is liable to all conditions and measurements
stated in this document.
Possible Cause
Clamp not closed
Threaded spindle dirty
Threaded spindle worn out
Jaws bent open
Load is dirty
Lifting shackle overloaded
Clamp overloaded
Clamp overloaded
Clamp overloaded
Incorrectly assembled
Threaded spindle dirty
Threaded spindle bent
Clamp worn out
Clamp contaminated
13
Action
Close clamp
Clean spindle
Reject clamp
Reject clamp
Clean load
Reject clamp
Reject clamp
Reject clamp
Reject clamp
Fit new retaining pins
Clean spindle
Reject clamp
Reject clamp
Clean clamp