Cleaning The Reflector; Accessories - ETC CE Source Four Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Figure 1
Retainer bolt 2
Lamp housing
Reflector housing
Reflector
Barrel rotation knob
CE Source Four

Cleaning the reflector

Remove the lens tube. Remove dust from the reflector with a blast of oil-
free air into the reflector area. If this is not sufficient, follow the instructions
below. You will need a crosshead screwdriver to complete this procedure.
Warning: Disconnect the unit from power before cleaning reflector.
Warning: Do not use glass and window cleaners on the reflector.
Chemicals in these cleaners will stain the reflector.
1.
Remove the lamp housing (see Installing the HPL Lamp , page 8).
2.
Unscrew and remove the barrel rotation knob located at the bottom of
the barrel. Use a crosshead screwdriver to undo retainer bolt 2, located
at the top of the reflector housing.
3.
Grasp the barrel and rotate it 45° in either direction. Carefully remove
the barrel from the reflector housing and set it aside.
4.
Dampen a clean, lint-free cloth with alcohol or distilled water. (Alcohol is
recommended.)
5.
Gently wipe the reflector.
6.
Insert the barrel into the reflector housing with the pattern slot on top.
(Line up the triangles on both parts.)
7
Pressing in gently, rotate the barrel 45° clockwise until it settles into
position. Rotate the barrel anticlockwise 45°. The barrel should be firmly
attached and the triangles should line up again.
8.
Replace the barrel rotation knob and tighten the bolt.

Accessories

Pattern holder, A-size ...................................... 400PH-A
Pattern holder, B-size ...................................... 400PH-B
Pattern holder, glass ........................................400PH-G
6.25" (15.875cm) donut for 19-50º ................... 400DN
Donut for 10º ................................................... 410DN
Donut for 5º ..................................................... 405DN
6.25" (15.875cm) snoot for 19-50º ................... 400SN
6.25" (15.875cm) colour frame for 19-50º ........ 400CF
12" (30.48cm) colour frame for 10º .................. 410CF
14" (35.56cm) colour frame for 5º .................... 405CF
Drop-in iris assembly .......................................400RS
30" (76.2cm) safety cable, black ......................400SC
C-clamp ...........................................................400CC
50º lens tube ................................................... 400LT-50
36º lens tube ................................................... 400LT-36
26º lens tube ................................................... 400LT-26
19º lens tube ................................................... 400LT-19
10º lens tube ................................................... 400LT-10
5º lens tube ..................................................... 400LT-5
Fixture body (single clutch) ..............................400FB
Fixture body (double clutch) ............................ 405FB
Gel frame holder extender ..............................400GE
13

Publicité

Table des Matières
loading

Table des Matières