Switching Off - tomado TEB1301W Mode D'emploi

Use
Evenly spread the electric underblanket over your mattress, starting at the foot end. Approximately, the cord should be at
shoulder height. The electric underblanket can be used on both sides. Then, as usual, lay the fitted sheet over the bed, so that
the electric underblanket is between the mattress and the fitted sheet. Each time you make the bed, check that the electric
underblanket is flat and properly spread, before you switch it on.
CAUTION!
Make sure the electric underblanket is spread out fully flat and does not fold or crumple during use. We recommend
switching on the electric underblanket about 30 minutes before you go to sleep and covering it with a duvet to prevent
the heat from escaping.
• First connect the switch to the connection point in the underblanket by connecting the plug.
• Then insert the plug in the socket.
Switching on
Slide the ON/OFF and heating positions slider to heating position 1, 2 or 3 to switch on the electric underblanket. In activated
condition, the led of the selected heating position lights up.
Setting the heating position
Position 0: OFF
Position 1: minimum heating
Position 2: medium heating
Position 3: maximum heating
WARNING: If the electric underblanket is used for several hours,
we recommend setting the lowest heating position (position 1)
to prevent the user from overheating.
ATTENTION
• The electric underblanket heats up the fastest when you first switch on the highest temperature level.

Switching off

Slide the ON/OFF and heating positions slider to the OFF position (0) to switch off the electric underblanket. The heating
positions no longer light up.
ATTENTION
If the electric underblanket is not used for a number of days, switch the ON/OFF and heating positions slider to the
OFF position (0) and remove the plug from the socket. Then disconnect the switch from the electric underblanket by
removing the plug.
EN - 16