Adjusting Torque - Ryobi P214 Manuel D'utilisation

Using the chart, select the option that best matches the type
of bit, fastener, and material you will be using.
 Choose your APPLICATION.
 Choose the correct SPEED: (1/LOW OR 2/HIGH)
 Choose the correct MODE: (DRIVE, DRILL, OR
HAMMER)

ADJUSTING TORQUE

See Figure 8, page 11.
When using the drill-driver for various driving applications,
increasing or decreasing the torque helps prevent the
possibility of damaging screw heads, threads, workpiece,
etc. In general, torque intensity should correspond to the
screw diameter. If the torque is too high or the screws too
small, the screws may be damaged or broken.
The torque is adjusted by rotating the torque adjustment ring.
The torque is greater when the torque adjustment ring is
set on a higher setting. The torque is less when the torque
adjustment ring is set on a lower setting.
The proper setting depends on the type of material and the
size of screw you are using.
DRILLING/DRIVING SCREWS
See Figure 9, page 11.
WARNING:
Always use the auxiliary handle when using this tool to
help resist torque reactions. Binding or stalling of this
product could lead to serious personal injury.
• Lag screws up to 3/8 in. dia. by 1-1/2 in. long
• Hole saw up to 2 in.
• Spade bits up to 1-1/2 in.
• Drill bits up to 1/2 in.
• Drilling into metal
• Concrete screws
• Deck or wood screws up to 3 in.
• Self tapping screws
• Deck or wood screws up to 2 in.
• Small screws or delicate work that requires more control
• Drilling into masonry and concrete.
OPERATION
APPLICATION
 Install the auxiliary handle.
 Check the direction of rotation selector for the correct
setting (forward or reverse).
 Use LOW (1) speed for high torque applications and
HIGH (2) speed for fast drilling or driving applications.
Refer to Two-Speed Gear Train and Adjusting Torque.
 Secure the workpiece in a vise or with clamps to keep it
from turning as the bit rotates.
 Hold the drill firmly and place the bit at the point to be
drilled, or where the screw is to be driven.
WARNING
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and possibly
shock the operator. If you must drive a screw where
hidden wire may be present, always hold tool by insulated
gripping surfaces (handle) when performing the operation
to prevent a shock to the operator.
 Depress the switch trigger to start the drill.
 Move the bit into the workpiece, applying only enough
pressure to keep the bit cutting or driving the screw. Do
not force the drill or apply side pressure to elongate a
hole. Let the tool do the work.
SPEED
1/LOW
2/HIGH
1/LOW
2/HIGH
2/HIGH
7 — English
:
MODE
DRILL MODE
(TORQUE ADJUSTMENT
NOT ACTIVE)
DRIVE MODE
HAMMER MODE
(TORQUE ADJUSTMENT
NOT ACTIVE)