Entering The Date And Time - Waeco AirCon Service Center ASC 2500 G LE Notice D'utilisation

Initial start-up
5. Enter the password "3282".
6. The company data is shown in the third line of the display (7).
You can enter five lines, each with up to 20 characters.
The display shows the number of lines of company data after the
message "Enter company data" ("01" to "05").
Use the cursor keys  or  to select the line of company data you
want.
7. Use the keypad (8) and the cursor keys to enter the data.
To switch between upper and lower case, press the Info key
To delete a character, briefly press the C key.
To delete the current line, press and hold down the C key.
8. Press ENTER to confirm.
9. Press STOP. The set data is activated.
10. Press STOP again to access the standby menu.
7.5

Entering the date and time

The date and the time are printed along with the company data on every
service log.
1. In the basic menu, use the cursor keys  or  to select "Other
selections":
2. Press ENTER to confirm.
3. Use the cursor key  to select "Service".
4. Press ENTER to confirm.
5. Enter the password "8463".
6. Use the keypad and the cursor keys to enter the information.
7. Press ENTER to confirm.
8. Press STOP to access the standby menu.
88
Short selection
Free selection
Other selections
ENTER-OK
ASC 2500 G LE / ASC 3500 G LE
.
EN