Operating Procedures; Maintenance & Repair - ROBENS Fire Beetle Mode D'emploi

V. OPERATING PROCEDURES
1. Unfold the pot supports.
2. Completely close the gas feed by turning the flame control knob to the right (clockwise) to OFF position.
3. Remove the protective plastic cap from the gas cartridge and carefully screw on the stove for 3 turns – care should be
taken for a little gas will be lost to the atmosphere at this point. Do not overtighten for this may damage the stove's dual
leak-proof gasket that prevents leakage.
4. Turn the flame control knob to the left (counter clockwise) twice. Place a naked flame around 1-3cm from the burner and
the gas should ignite immediately.
5. A normal flame should be stable and burn upward with a blue or saffron yellow colour depending on flame control.
VI. DISASSEMBLY PROCEDURE
1. Turn the flame control knob fully to the right (clockwise) to the
OFF position and check the flame is completely extinguished.
2. Allow the stove to completely cool down. Hold the stove firmly, and then turn the gas cartridge clockwise to remove.
3. Fold in the pot supports and put the whole burner head into its protective storage bag.
VII. MAINTENANCE & REPAIR
1. When the pressure falls, gas cannot ignite. Check whether there is fuel remaining inside the gas cartridge – you will hear
and feel liquid gas move when you shake a cartridge. If gas remains the burner may be clogged. Clean away dirt using a
cloth dipped methyl alcohol.
2. Blow through the air intake to clean the burner and jet. Do not insert any use any pin into the jet for this may cause
damage, leading to a safety hazard.
3. Reinstall and firmly screw down the burner to ensure an airtight seal. Reinstall the gas cartridge according to the
described operation procedures.
4. Regularly inspect the integrated gas seal for damage. Apply warm soapy water at the joint and junction of the equipment
to highlight leaks through the formation of bubbles. If you hear or smell gas don't attempt to ignite the appliance if you
can hear or smell leaking gas. If you smell gas: Do not attempt to ignite equipment; Put out all flames; Disconnect fuel
supply
5. To avoid creating a safety hazard and invalidation any warranty do not in any way attempt to maintain, modify,
disassemble and repair your stove unless covered by this manual.
I N S T R U C T I O N M A N U A L
3