Operate The Smart Thermostat Head With A Remote Control; Disconnect All Remote Control Devices Via The Smart Thermostat Head; Operating The Heating Control Set With Homewizard; How Do I Add The Smart Thermostat Head To The Homewizard App - Smartwares SHS-53002-EU Manuel D'utilisation

7.2.2

Operate the smart thermostat head with a remote control

1 Set the preferred smart thermostat head to a high and low temperature. See sub-section
7.1.3 for more information.
2 Perform one of the following actions:
3 Press the ON button to connect the smart thermostat head to the high adjusted
temperature.
4 Press the OFF button to connect the smart thermostat head to the low adjusted
temperature.
7.2.3

Disconnect all remote control devices via the smart thermostat head

1 Keep the Menu button pressed until 'Pro' appears on the display.
2 Choose 'UnL' by turning the dial button.
3 Press the OK button.
'UnL' flashes on the display.
4 Press OK to disconnect all paired remote control devices. Press the Menu button to canceln.
Notice! This device is compatible with HomeWizard. HomeWizard enables you to operate
this device with an app on your Smartphone or tablet. For more information about
HomeWizard visit the website www.HomeWizard.com.

7.3 Operating the heating control set with Homewizard

7.3.1

How do I add the smart thermostat head to the HomeWizard app?

Notice! The smart thermostat head can be linked to up to 3 external devices. When the
memory is full, (FULL) appears on the display. Refer to Chapter 9 for more information.
1 Open the HomeWizard app on your
Smartphone or tablet.
2 Keep the Menu button pressed
until 'Pro' appears on the display.
3 Choose 'rFS' by turning the dial button.
Notice! Make sure that you choose 'rFS' and not 'rES'. When you chose 'rES' and follow
the steps below, you reset the smart thermostat head to the factory setting
4 Press the OK button.
The smart thermostat head waits in the coupling position. Within 30 seconds the smart
thermostat head can be linked-up with the HomeWizard app.
5 On the upper left corner of the screen, press the 'Menu' button (the three lines above each
other). The menu appears.
6 Press 'New Sensor'.
Tip! Move your finger across the screen to search.
7 Press 'Thermostatic head'.
User manual – wireless climate control kit 29