Assembly And Installation; Preparation For Assembly; Assembly On A Standard Valve - Smartwares SHS-53002-EU Manuel D'utilisation

4 Press OK to confirm.
On the display the day is flashing.
5 Turn the dial button to set the day.
6 Press OK to confirm.
On the display the hour is flashing.
7 Turn the dial button to set the hour.
8 Press OK to confirm.
The minutes are flashing on the display.
9 Turn the dial button to set the minutes.
10 Press OK to confirm.
The valve turns in the product and 'ins' is shown on the display. The product is now ready
to be mounted on the radiator.
Notice!
• Do not press OK again before the product is mounted on a heater.
• When you wait too long with the setting of the date or the time, the product takes it for
granted that the settings have been completed. The valve turns again in the product.

6 Assembly and installation

Notice!
• Follow the steps of chapter 5 if you have not done so already.
• Do not press OK before the product is assembled on a radiator.
• The water from the heating system needs not to be drained when assembling the
product.

6.1 Preparation for assembly

• If present, remove the old tap of the radiator. Consult the manual or website of the
manufacturer for an exact description.
Notice! Turn the tap to close before removing it. Remove the tap by turning it counter-
clockwise.
• For assembly on a standard valve, follow the steps in paragraph 6.2 and for a Danfoss
valve, follow the steps in paragraph 6.3.

6.2 Assembly on a standard valve

1 Pull out the fixing ring until a 'CLICK' is heard.
2 Push the product onto the radiator.
3 Fasten the fixing ring by turning it clockwise.
The product is now mounted to the radiator.
22 User maual –wireless climate control