Chemfree SmartWasher 15 Sink Mode D'emploi page 5

OzzyJuice
The SmartWasher uses a specially
formulated fluid which provides a
combination of excellent cleaning
characteristics, safety and nutrition for
the Ozzy microbes. OzzyJuice is
provided in ready-to-use containers.
DO NOT ADD WATER, SOLVENT, MINERAL
SPIRITS, GASOLINE OR KEROSENE TO
YOUR SMARTWASHER!
To help monitor and maintain the proper
fluid level, the SmartWasher is equipped
with a low fluid level indicator. When the
"Add Fluid" light comes on, add a 5
gallon box of OzzyJuice immediately.
When a container of OzzyJuice is added
the light will go out. When the "Add
Fluid" light comes on the heater will turn
off until the necessary amount of fluid is
added.
Remember, the OzzyMat needs to be
replaced every 30 days.
To Add OzzyJuice
Slowly pour a full container of OzzyJuice directly into the
SmartWasher sink. The "Add Fluid" light should go out.
If you add a container of OzzyJuice to your machine and
the low fluid light is still on, lift up on the sink and check to
see if the float is in the down position. If the fluid is below
the float and the float is not at the top stop, you will need
to add more fluid. If the fluid is over the float, there may be
a problem with the low fluid indicator and you should call
your service representative.
2
Add Fluid
light
ChemFree Technical Support • 1-800-521-7182
Temperature
Your SmartWasher should be plugged in 24 hours a day, 7
days a week to maintain optimal temperature.
The thermostat is factory-set to maintain fluid temperature
at
105° F (+-5°) (40° C) (+-3°)
optimum condition for effective cleaning and activity of
Ozzy microbes.
The heater will not operate when the fluid level becomes
low. Lift the sink up and check your fluid level. Your
SmartWasher should have approximately 8" (20 cm.) of
fluid in it. If the fluid lever is lower than that, add
OzzyJuice. If, after a reasonable warm-up period, the fluid
temperature seems too hot or too cold, please refer to the
"Troubleshooting" section on page 3.
If the temperature falls below the recommended minimum,
the system will still clean, but remediation of the
hydrocarbons by the Ozzy microbe colony will slow down.
The Ozzy microbes will become more active when the fluid
temperature reaches the appropriate level.
PROPER USE AND CARE OF THE
SMARTWASHER
To keep your new system operating at its best, please
remember these important hints:
• The heater is disabled as long as the "Add Fluid" light
is on.
• The SmartWasher is designed to "eat" the oil and
grease washed from dirty parts. It is NOT designed to
function as a waste-oil dump! The Ozzy microbes will
thrive on oil and grease washed from parts during
normal use. If excessive oil, gasoline, transmission
fluid, antifreeze or similar fluid is dumped into the
system, the Ozzy microbes may be destroyed.
• DO NOT ADD - water, bleach, disinfectants,
insecticides or biocides of any description.
• Change the OzzyMat every month.
• To maintain the effectiveness of the SmartWasher it is
imperative that nothing be added to OzzyJuice other
than replacement OzzyJuice, or dirty parts residue.
• Turn off pump when not actually washing parts. This
will help to decrease fluid evaporation.
. This temperature provides the