KitchenAid 521.500 Instructions D'origine page 20

SETTING UP YOUR STAND MIXER
INSTALLATION: The stand mixer shall be installed on a level and stable
surface such as a countertop or work table.
To Lower Bowl
1. Rotate lever back and down.
To Attach Flat Beater, Wire Whip,
or Dough Hook
1. Turn Speed Control Lever to "0" (OFF).
2. Unplug Stand Mixer or
disconnect power.
3. Raise Guard.
4. Slip Flat Beater
on Beater Shaft
and press upward
as far as possible.
5. Turn beater to right, hooking beater
over the pin on shaft.
To Remove Flat Beater, Wire Whip,
or Dough Hook
1. Turn Speed Control Lever to "0" (OFF).
2. Unplug Stand Mixer or disconnect
power.
3. Raise Guard.
4. Press beater upward as far as
possible and turn left.
5. Pull beater from Beater Shaft.
Speed Control Lever
The Soft Start feature minimizes
splash-out by starting the mixer slowly
before increasing to the selected
speed. To further reduce the potential
for splash-out, always begin mixing
using Speed 1, then gradually move
to higher speeds as needed. See
"Speed Control Guide".
Removable Pouring Chute
The Removable Pouring Chute is easily
attached to the front of the Guard as
shown in the illustration above. It provides
a convenient way to add ingredients to the
Stand Mixer bowl.
Auto-Reset Motor Protection
If the Stand Mixer stops due to overload,
slide the Speed Control Lever to "0"
(OFF) and unplug the Stand Mixer. After
a few minutes, the Stand Mixer will
automatically reset. Plug the Stand Mixer
back in and slide the Speed Control Lever
to the desired speed and continue mixing.
If the Stand Mixer does not restart, unplug
the Stand Mixer for a longer period of time
to allow it to cool, then plug back in and
restart the Stand Mixer. If the Stand Mixer
does not restart, see "When You Need
Service".
Stop Switch
If you need to stop the Stand Mixer
immediately during use, press the Stop
Switch. To resume operation, reset the
Speed Control Lever to "0" (OFF), and
pull out the Stop Switch. Then, your Stand
Mixer is ready to be used normally again.
7