Using The Soundbar; Pairing Mode - LENCO SB-080 Mode D'emploi

Operating INSTRUCTIONS

Using the soundbar

1. Switch on the soundbar by using the power button on the soundbar or by using the
Standby button on the remote control. After switching it on, the default input mode
will Be shown on the display
2. lnput modes can be changed by pressing the power button again or by using the
INPUT button on remote
Below are input mode names appearing in the soundbar display:
Note: USB input mode is not available in the source selection. lt will be available only
after inserting a compatible USB Drive (appears as US in display)

Pairing Mode

Connect
1. Plug in the power cord and the display will lit up, display shows [--] which means
the unit is in standby mode
2. Switch on the soundbar by pressing the power button and then change the input
mode to Bluetooth. The display will show [bt]. If no device was previously paired,
the display will show a blinking [bt].
3. Search for new Bluetooth devices on your Bluetooth audio player (for example:
smartphone/tablet/computer). Choose the device named 'Lenco SB-080' from the
list of the detected devices. lf a password is requested just type 0000. The blinking
[bt] will stop flashing and a beep will sound when the sound bar is successfully
paired.
4. The soundbar will remember the last paired device and reconnects the next time
you switch on the soundbar in Bluetooth mode. (The previously paired device must
be in the neighborhood of the sound bar with the Bluetooth function activated)
Note: When your device was unable to detect the soundbar while pairing, please
restart the bluetooth mode and try to pair again.
Disconnect
Go to the Bluetooth settings of your Bluetooth audio player, select 'Lenco SB-080'
from the list of devices and choose the option 'disconnect'.
Note: You have to disconnect from your Bluetooth audio player if you want to connect
a different BT player.
7