General Safety Instructions; Safety Instructions For Operation - Husqvarna K 535i Manuel D'utilisation

loading and susceptibility to twisting or binding of the
wheel in the cut and the possibility of kickback or
wheel breakage.
• When wheel is binding or when interrupting a cut
for any reason, switch off the power tool and
hold the power tool motionless until the wheel
comes to a complete stop. Never attempt to
remove the wheel from the cut while the wheel is in
motion otherwise kickback may occur. Investigate
and take corrective action to eliminate the cause of
wheel binding.
• Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed and
carefully re-enter the cut. The wheel may bind, walk
up or kickback if the power tool is restarted in the
workpiece.
• Support panels or any oversized workpiece to
minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under their
own weight. Supports must be placed under the
workpiece near the line of cut and near the edge of
the workpiece on both sides of the wheel.
• Use extra caution when making a "pocket cut"
into existing walls or other blind areas. The
protruding wheel may cut gas or water pipes,
electrical wiring or objects that can cause kickback.

General safety instructions

WARNING: Read the warning instructions
that follow before you use the product.
• This product is a dangerous tool and can cause
serious injury if it is not used careful or if used
incorrectly. It is very important that you read and
understand the contents of this manual.
• Do not change the product without an approval from
the manufacturer. Do not use a product that has
been changed by others and always use original
accessories. Changes that are not approved from
the manufacturer can result in serious injury or death
to the operator or others.
• Keep the product clean. Signs and decals must be
fully visual.
• This product produces an electromagnetic field
during operation. This field may under some
circumstances interfere with active or passive
medical implants. To decrease the risk of serious
injury or death, we recommend persons with medical
implants to turn to their physician and the medical
implant manufacturer before operating this product.

Safety instructions for operation

WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electrical
shock, fire and/or serious injury.
745 - 008 - 12.11.2018
• Do not cut asbestos materials.
• When dry cutting, make sure the dust is removed
safely.
• The information in this manual is not a replacement
for professional knowledge and experience. If you do
not feel safe in the situation that you are in, stop the
product. Do not use the product in unknown
situations.
• Turn to your servicing dealer or Husqvarna if you
have questions about the operation of the product.
We can give you information about how to operate
your product safely with best result.
• Do not use a product, battery or battery charger that
is defective.
• Do not touch a rotating cutting blade. It can cause
serious injuries or death.
• Do not use the product in bad weather, for example,
heavy fog or rain, strong wind and intense cold. Bad
weather add risks such as ice on the ground.
• Do not start a product unless all covers and guards
are assembled correctly.
• Look around you. Make sure that there is no risk that
persons or animals touch or influence on your
control of the product.
• Do not let children use or be near the product. The
product is easy to start. This can mean a risk of
serious injury.
• Remove the battery when you do not have full view
of the product. Remove the battery if you will not use
the product for a long time.
• You must be stable on your feet in order to have full
control of the product. Do not use the product if you
are on a ladder. Do not use the product if you are not
on stable ground.
• Do not use the product above shoulder height.
7