Basic Working Techniques - Husqvarna K 535i Manuel D'utilisation

2. Press the battery release buttons and remove the
battery from the battery holder.
WARNING: Remove the battery when you
do not use or when you do not have full
vision of the product. This is to prevent
accidental start.

Basic working techniques

WARNING: Do not move the power cutter to
the side. This can prevent the free
movement of the blade and cause the blade
to break, which can cause an injury.
WARNING: Do not use the side of the
blade. The blade can become damaged and
broken, which can cause an injury. Use only
the cutting edge.
WARNING: Do not use a diamond blade to
cut plastic material. The heat that occurs can
melt the plastic. Melted plastic can attach to
the cutting blade and cause a kickback.
• The product is made for high speed diamond blades
approved for handheld power cutters.
• The product is made to cut in to tiles, light concrete
and stone. Use only for this type of operation.
• Make sure that the cutting blade does not show
signs of damage and that it is attached correctly, see
Abrasive blades on page 10 and To attach the
cutting blade on page 13 .
• Make sure to use the correct cutting blade for the
type of operation, see
high speed power cutters on page 10 .
• Do not cut asbestos material.
• Always hold the power cutter with 2 hands. Always
hold the product tightly with thumbs and fingers
around the handles. Always hold the rear handle
with the right hand and the front handle with the left
hand.
16
Cutting blades for handheld
• Always be parallel to the cutting blade. Do not be
linearly behind the cutting blade. If there is a
kickback, the power cutter moves in the plane of the
cutting blade.
• Keep a safe distance to the cutting blade when the
engine operates.
• Make sure that you are in a stable position during
operation.
• Keep applicable distance from the object you are
cutting.
• Do not operate above shoulder height. Use a
platform or scaffold if the cutting operation is above
shoulder height. Do not overreach.
• Do not operate from a ladder.
• Make sure that the cutting blade is free when the
engine is started.
• Always monitor the product when the engine
operates.
• Do not move the product when the cutting blade
rotates.The product has a electrical retarder to
decrease the blade stop time.
• Make sure that the front ground support is flush with
the work piece at the rear. The blade guard collects
745 - 008 - 12.11.2018