Tip-Over Protection; Overheat Protection - HAEGER Elan IX OH-009.006A Mode D'emploi

Radiateur d'huile

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

English

–

The radiator will reduce the effects of cold draughts to a minimum.

–

The appliance must not be positioned directly underneath a fixed power

point.

–

Do not use the appliance in rooms with a surface area of less than 4m².

Connection

The radiator must be connected to a perfectly functioning 230V AC socket with

correct poles.

Avoid contact between clothing, household linen, furniture, inflammable

material and the socket providing power to the radiator.

Operating your oil-filled heater

1. Room temperature can be adjusted using the thermostat. Simply turn the

thermostat knob clockwise, to increase the heat, and anti-clockwise to

decrease the temperature, until you reach the desired temperature.

2. Turn the power switch from "0" to either "●" (Minimum heating), or "●●"

(Medium heating) or "●●●" (Maximum heating).

3. The pilot lights up when activated.

4. Turning the

temperature.

5. Turning the thermostat anti-clockwise will decrease the "set" temperature.

6. Do not cover the heater at any time during operation. There is a risk of fire

if the heater is covered.

7. Once you have finished using your heater, turn the power switches off, and

the thermostat control switch to the "0" position, and unplug from the

mains supply.

IMPORTANT: When in use, the radiator should always be kept vertical

(wheels at the bottom, controls at the top). Any other position could be

dangerous!