CDVI TERENA Manuel D'installation page 3

INSTALLATION MANUAL
TERENA - TERENA16
Web Based Access Control
- In the address bar in your browser, enter the following address:
http://192.168.0.100:8087/admin and then confirm.
- Enter the login (admin) and the password (terena) and click OK.
- Select the appropriate language.
- Click on Initialize data, then at the end of the operation, click OK.
- Enter your network settings as well as the date and time in the fields on the right.
- Click on Apply the settings, then at the end of the operation, click OK.
- Click on the Restart icon and click OK. Confirm the operation by clicking OK.
Wait a few moments for the message "Please wait... Rebooting the system" and click OK.
The green light (PWR) goes off.
- Close your internet browser.
- Wait for the green light (PWR) to come on next to the USB socket on the TERENA unit
and for the flashing light (LOW BATT) to come on.
HOW TO USE THE CONTROL UNIT
- Open the internet browser on your PC (minimum requirements: IE 8, FireFox 3.6,
Chrome 5, Safari 4 or Opera 10.5).
- In the address bar in your browser, enter http://192.168.0.100:8087/ and then confirm.
- Enter the login (superviseur) and the password (12345), then click OK.
- The central control unit is now ready to use.
RECOMMENDATIONS
- Do not store the central control unit without protecting the CR2032 lithium battery.
- After an update, you should clear the cache in your browser. To do so,
press CTRL+SHIFT+DEL in FireFox or IE.
- If you lose sensitive data such as the login, passwords and IP settings, connection
to the TERENA unit will be impossible.
SECURE SHUTDOWN
To ensure that the central unit shuts down safely, the DIP switch 2 on the 4-position
DIP switch terminal should be in the ON position. The LOW BAT LED flashes, indicating
that a secure shutdown procedure is in progress. Wait until the RX, TX, AL and SCR LEDs
go off before disconnecting the TERENA and the battery. After a shutdown to reboot,
do not forget to set the DIP switch 2 back to the OFF position (for normal functioning).
Reconnect the battery first before connecting the mains cable (the battery alone cannot
power up the TERENA).
EN
cdvi.com
3
cdvigroup.com