Automatic Search - Ten Haaft SamySolar Manuel D'utilisation

Automatic search

After switching on the system by pressing
the position in which a satellite was last received. If no satellite is found, the sys-
tem starts the fully automated search for the preset satellite (default setting: Astra
1). If you wish to change the preset search satellite, please refer to section „Satellite
settings".
E
When the search satellite is found, the search function stops and the TV signal is
looped through. If no TV picture appears after an extended search (several
minutes), you are most likely located in an area in which the preset sa-
tellite cannot be received or the signal beam is obstructed. In this case, the
message „No satellite found" appears in the display of the control panel. Then ano-
ther search satellite should be selected or the obstacle be removed or the vehicle
position be changed, if required.
The automatic search function always assumes that your vehicle is perfectly level. If
this is not the case the search time may be extended.
If the antenna is already open, the automatic search function is started as follows:
Press until the message „Automat. search" appears in the display.
Press .
Basically, no satellite receiver must not be connected or switched on to perform a
satellite search. However, if no receiver is switched on when the automatic search
ends, a corresponding message is shown in the display to alert you that no image or
sound signals are received.
, the antenna opens and moves into
60