Replacing The Compressor's Filter; Application; Preparing Accessories; Preparing The Unit - DTF MEDICAL PURENEB CLASSIC AEROLIGHT Notice D'utilisation

d) Replacing the compressor's filter
The unit is equipped with a filter that removes potential impurities from the compressor's intake air.
On a regular basis, or if the unit loses its effectiveness (increased aerosol therapy session time), check the
filter and change it if it is soiled. To carry out a check or a replacement, lift the cap for the filter holder. If
needed, remove the filter using tweezers.
1. Place the unit on its side
a) Preparing accessories
Follow the exact order of the following steps.
1. Insert the M selector into the upper
part of the nebulizer by lining it up with
the deflector
Deflector
6. Connect the pressure tube
under the nebulizer
b) Preparing the unit
Follow the exact order of the following steps.
1. Connect the tube to the
NOTE: Connect the nebulizer to the unit before turning it on.
2. Remove the cap for the filter
5.
5. Connect the mouth piece or, if not, the mask to
2. Connect the unit's plug
unit
holder

Application

2. Connect the atomizer to the
reservoir
the nebulizer
18
3. Change the filter if needed
3. Pour the solution into
the reservoir
4. Fasten the top of the
nebulizer to the reservoir
3. Press the "on/off"
button