Installing The Leveling Legs - Rotel U902CH1 Mode D'emploi

Photo shown may vary from product
 INSTALLING THE LEVELING LEGS
o
Install the legs by screwing them into the screw holes on the unit. (Please note that
the leg that is positioned on the hinge is shorter than the others. )
 MAINTENANCE
o
The unit should be cleaned and maintained once a month.
o
When performing maintenance, make absolutely sure the power is disconnected.
o
Wipe the inner and outer surface of the unit and its accessories with a soft cloth. If
the unit is very dirty, a neutral detergent can be used, and rinsed off using clean,
cold water. After cleaning, it is recommended that the unit surface be polished
using glass wax and a soft flannel or duster.
o
For cleaning, do not use scourers, hot water, petrol, alcohol, kerosene, washing
powder, alkaline detergent, bleach, abrasive cleaners etc as they can damage the
protective surface of the unit. Do not spray or pour water directly onto the unit –
apply only with a cloth.
 TROUBLESHOOTING
o
When the unit does not work

Check to see if there is a power failure.

Check to see if there is power in the electrical outlet you have plugged into.
o
When the refrigerator is not cooling sufficiently

The bottles may be packed too tightly together inside the unit, blocking the
flow of cool air.

The door may not have been closed properly.

The door gaskets may be damaged.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use