Antenna Assembly; Transmitter Battery Installation - Nikko Vaporizr 2 Manuel D'utilisation

94155_Vaporizr2_8L_IM.pdf 9 21/4/15 6:04 pm
PLEASE CHECK THE HEADINGS I - VIII WITH THE DIAGRAMS IN PAGES 1, 2, 3, 4.
VaporizR 2
A
D 1,5V (AAA/LR03) battery x3
1. Insert antenna wire from product into tube.
2. Slide tube down antenna wire and into hole in product.
3. Tie knot with any remaining antenna wire (Do not pull wire tight).
C
M
To remove battery lid, loosen screw to open.
1.
Y
2. Slide open the battery lid in the direction as shown in the figure.
3. Insert 1,5V (AAA/LR03) batteres x3 with the polarity (+/-) as shown on the bottom of battery compartment.
CM
Replace the battery lid, following the removal procedure in reverse.
MY
NOTE: For best performance, always use alkaline batteries only. To remove the batteries, reverse the
CY
installation procedure.
There is no on/off switch on the Transmitter. Moving the sticks turns it on automatically.
CMY
K
THIS PRODUCT SHOULD BE USED WITH ADULT SUPERVISION.
1. Fully charge 6,0V NiMH battery pack in advance of your use.
2. Turning off vehicle.
3. Turn the latches located underneath of vehicle to unlock battery lid as shown in the figure with arrows.
4. Loosen screw to open battery lid.
5. Remove battery lid.
6. Insert 6,0V battery pack into battery compartment with correct polarity (+/-). Place battery lid back in
position and lock properly.
NOTE: To remove the batteries, reverse the installation procedure.
I - CONTENTS & FEATURES
Transmitter
B
E NiMH Battery charger
II - ANTENNA ASSEMBLY
III - TRANSMITTER BATTERY INSTALLATION
IV- VEHICLE BATTERY INSTALLATION
EN
Rechargeable 6,0V NiMH battery pack
C
8