dirna Bergstrom TRP DYNAMIC Instructions De Montage page 23

DYNAMIC
8
On the studs, thread (4) M6 nuts with (4) flat
washers Ø 6, which should be level with the
cover.
SEE ATTACHED DIAGRAM
VERY IMPORTANT
!
In the case of slanting upholstery, the
evaporator unit must be vertical to prevent
the condensation water from dropping onto
the upholstery.
9
Pass the waste water pipe through the bore
of the evaporator base and connect to the
tray.
10
Pass the cabling through the Ø 35 bore
towards the exterior.
OPERATIONS VALID FOR ALL MODELS
Upholstery
Evaporator
bracket
Waste water
tray
Waste water pipe
10
Lorry sheet
OUTSIDE
M6 self-blocking
nut
Protector cap
M6 Stud
Wide ring flat
washer
Rubber washer
9
23
Upholstery
INSIDE
Evaporator M6 Nut
base (leave at
M6 Nut upholstery height)
M6 Nut
Wide ring
Wide ring
flat washer
flat washer
EN
®
8
10