Safety Notes; Functional Description; Intended Use; English | 13 - Bosch PLS 300 Notice Originale

Safety Notes

en
General Safety Rules
Read all warning notes and in-
WARNING
structions enclosed with the
sawing station and the power tool to be mount-
ed. Failure to follow the warnings and instruc-
tions may result in electric shock, fire and/or se-
rious injury.
Safety Warnings for Sawing Stations
Pull the plug from the mains receptacle
and/or remove the battery from the power
tool before making adjustments on the tool
or changing tool accessories. Unintentional
switching on of the power tool is the cause of
many accidents.
Assemble the sawing station in the proper
manner before mounting the power tool.
Safe guiding of the power tool is possible on-
ly when the sawing station is properly assem-
bled.
Place the sawing station on a firm, level and
horizontal surface. If the sawing station can
slip off or wobbles, the power tool or the
workpiece cannot be uniformly and securely
guided.
Attach the power tool securely to the saw-
ing station before using it. Slipping off of the
power tool on the sawing station can lead to
loss of control.
Take care that the cable of the power tool
does not come between the base unit and
the guide rail. When the cable is damaged or
cut through, there is danger of electric
shock.
Remove the power tool before modifying
the sawing station or folding up the guide
rails. The power tool can fall down, become
damaged or cause injuries.
Bosch Power Tools
Do not use a defective sawing station. Only
an intact sawing station can guide the power
tool securely.
Ensure that long and heavy workpieces do
not affect the equilibrium of the sawing sta-
tion. Long and/or heavy workpieces must be
supported at the free end.

Functional Description

Read all warning notes and instruc-
tions enclosed with the sawing sta-
tion and the power tool to be
mounted. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.

Intended Use

The sawing station is intended for operation ex-
clusively with PST jigsaws from the Bosch DIY
program and jigsaws with a base plate width of
67,45 ± 0,15 mm.
Together with the power tool, the sawing sta-
tion is intended for sawing straight lengthway
and crossway cuts in boards and profiles of
hardwood and softwood, as well as aluminium
and plastic. In this, mitre angles from –45° to
+45° as well as bevel angles from 0° to 45° are
possible.
Only use the saw blades recommended by
Bosch (see page 76). When using saw blades
that are too thin, danger is given that the cut
runs out of centre.

English | 13

1 609 929 S38 | (15.9.09)